
986LCD-M Family
Incl. CRT, PS/2
Kbd/Mse and HD
3.6 Power Consumption
In order to ensure safe operation of the board, the ATX power supply must monitor the supply voltage and
shut down if the supplies are out of range – refer to the hardware manual for actual power specification.
The 986LCD-M board is powered through the ATX connector and the additional 12V separate supply for CPU
as specified in the ATX specification; besides this the power supplied to the board must be within the ATX
specification.
The requirements to the supply voltages are as follows:
Test system configuration
The following items are used in the test setup:
1. 986LCD-M board equipped with CPU, RAM and 12V active cooler if required
2. ATX PSU
3. CRT, PS/2 keyboard & mouse and HD
4. Tektronix TDS 7404, P6345 probes
5. Fluke Current Probe 80i-100S AC/DC
Note: The Power consumption of CRT, Fan and HD is not included.
Test results:
The power consumption of the 986LCD-M Board is measured under:
1- DOS, idle, mean
2- WindowsXP, Running 3DMARK & CPU BURN, mean
3- WindowsXP, Running 3DMARK & CPU BURN, peak
4- S1, mean
5- S3, mean
6- S4, mean
7- Inrush, peak
Supply Min Max Note
Vcc3 3.135V 3.465V
Should be ±5% for compliance with the ATX specification
Vcc 4.75V 5.25V
Should be ±5% for compliance with the ATX specification
+12V 11.4V 12.6V
Should be ±5% for compliance with the ATX specification
–12V –13.2V –10.8V
Should be ±10% for compliance with the ATX specification
-5V -5,50V -4.5V Not required for the 986LCD-M/mITX board
5VSB 4.75V –5.25V
Should be ±5% for compliance with the ATX specification
Kommentare zu diesen Handbüchern