Kontron CP6004-RC Bedienungsanleitung PDF herunterladen (Seite 34)

Introduction CP6004-RA/-RC

Page 1 - 14 ID 1055-1509, Rev. 1.0

D R A F T — F O R I N T E R N A L U S E O N L Y

Chipset

Intel® QM77 Mobile Intel® QM77 Express Chipset:

• Two x4 or eight x1 PCI Express 2.0 ports operating at 5 GT/s (only one

x4 PCI Express port is used on the CP6004-RA/-RC)

• SATA host controller with five ports and RAID 0/1/5/10 support

• One SATA 6 Gb/s ports accessible via an onboard connector

• Four SATA 3 Gb/s ports accessible via rear I/O

• USB 2.0 host interface with up to 14 USB ports available (only six ports

are used on the CP6004-RA/-RC)

• USB 3.0 host interface with up to 4 USB ports available (not used on the

CP6004-RA/-RC)

• Integrated Ethernet controller

• SPI flash interface support

• Low Pin Count (LPC) interface

• Power management logic support

• Enhanced DMA controller, interrupt controller, and timer functions

• System Management Bus (SMBus) compatible with most I²C™ devices

• DMI 2.0 with 5 GT/s and FDI interfaces to the processor

• High Definition Audio (HDA) interface

• Analog display port

• Three digital display ports

• Integrated RTC

Integrated

Controller

Graphics controller High-performance 3D graphics controller integrated in the processor:

• Support for two independent displays

• Supports analog displays (CRT) up to a resolution of 2048 x 1536

pixels with 32-bit color @ 75 Hz

• Supports digital displays (HDMI/DVI) up to a resolution of 1920 x

1200 pixels @ 60 Hz

• Supports digital display (DP) up to a resolution of 2560 x 1600 pixels

@ 60 Hz

• Dynamic Video Memory Technology (DVMT)

Interfaces

CompactPCI

Compliant with the CompactPCI Specification PICMG

2.0 R 3.0:

• System controller operation

• 64-bit/66 MHz PCI or PCI-X master interface with dedicated PCIe-to-

PCI-X bridge

• 3.3V or 5V signaling levels (universal signaling support)

Compliant with the Packet Switching Specification PICMG 2.16.

The CP6004-RA/-RC supports System Master hot swap functionality and

application-dependent hot swap functionality when used in a peripheral slot.

When used as a System Master, the CP6004-RA/-RC supports individual

clocks for each slot and the ENUM signal handling is in compliance with the

PICMG 2.1 Hot Swap Specification.

When installed in a peripheral slot, the CP6004-RA/-RC is isolated from the

CompactPCI bus. It receives power from the backplane and supports rear I/O

and, if the system supports it, packet switching (in this case up to two channels

of Gigabit Ethernet).

Table 1-2: CP6004-RA/-RC Main Specifications (Continued)

FEATURES SPECIFICATIONS

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare

Kontron CP6004-RC Bedienungsanleitung Seite 34

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Kontron CP6004-RC