Kontron COMe Ref.Carrier-i T10 Bedienungsanleitung PDF herunterladen (Seite 11)

COMe Reference Carrier-i Type 10 / Specification

3.5 Environmental Specification

Ambient temperature

» Operating: -40°C to +85 °C

» Non-operating: -40 to +85 °C

Humidity

» Operating: 10% to 90% (non condensing)

» Non operating: 5% to 95% (non condensing)

3.6 MTBF

The following MTBF (Mean Time Between Failures) values were calculated using a combination of manufacturer‟s test

data, if the data was available, and a Bellcore calculation for the remaining parts. The Bellcore calculation used is

“Method 1 Case 1”. In that particular method the components are assumed to be operating at a 50 % stress level in a

40° C ambient environment and the system is assumed to have not been burned in. Manufacturer‟s data has been

used wherever possible. The manufacturer‟s data, when used, is specified at 50° C, so in that sense the following

results are slightly conservative. The MTBF values shown below are for a 40° C in an office or telecommunications

environment. Higher temperatures and other environmental stresses (extreme altitude, vibration, salt water

exposure, etc.) lower MTBF values.

» System MTBF: tbd hours

The whole carrier board was designed to accomplish industrial temperature range. This was not possible for all

connectors and chips. Following devices have a different temperature rating:

» Audio Codec: -20°C to +85°C

» DVI Connector: 0°C to 60°C

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Keine Kommentare

Kontron COMe Ref.Carrier-i T10 Bedienungsanleitung Seite 11