Kontron AT8402 User Manual Bedienungsanleitung PDF herunterladen (Seite 60)

AT8402 Hardware Description

Page 3 - 27 AT8402 User Guide

Connection to the RJ45 can be established with a straight through Ethernet cable and a RJ45

(female) to SubD (female) adapter if required. The adapter is described in the following table.

Table 3-22: Serial console terminal cable interface: RJ45 Female to DB9 Female

3.2.2 Fast Ethernet Management Interface

The Fast Ethernet port of the PowerPC 405 GP is used as a management interface. The ex-

ternal FE PHY device on the front board is connected to the RJ45 connector of the RTM.

The default setting of the AT8402's PHY is to operate in autonegotiation enabled mode, 10/100,

Full or Half duplex. The two LEDs of the RJ 45 connector are controlled by the CPLD.

The connection is established with a straight through Ethernet cable.

Table 3-23: FE Port (RJ45) Pin Assignment

Number

Signal

1TX+

2TX-

3RX+

4NC

5NC

6RX-

7NC

8NC

RJ45 Female RJ45 Pin

Number

Signal Connected Description DB9 Pin

Number

DB9 Female

1 RTS Y Request To Send 8

2 DTR Y Data Terminal Ready 6

3 TXD Y Transmit 2

4 GND N Ground -

5 GND Y Ground 5

6 RXD Y Receive 3

7 DSR Y Data Set Ready 4

8 CTS N Clear To Send 7

- RI N Ring Indicator

(Not used)

Front View

- DCD N Carrier Detect

(Not used)

Front View

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 88 89

Keine Kommentare

Kontron AT8402 User Manual Bedienungsanleitung Seite 60