Kontron AT8902M CLI Bedienungsanleitung PDF herunterladen (Seite 146)

Routing Commands AT8902M

AT8902M CLI Reference Manual Page 3 - 32

Mode Router OSPF Config

3.7.24 distribute-list out (OSPF)

Use this command to specify the access list to filter routes received from the source

protocol.

Format

distribute-list <1-199> out {rip | static | connected}

Mode Router OSPF Config

3.7.24.1 no distribute-list out

Use this command to specify the access list to filter routes received from the source

protocol.

Format

no distribute-list <1-199> out {rip | static | connected}

Mode Router OSPF Config

3.7.25 exit-overflow-interval (OSPF)

This command configures the exit overflow interval for OSPF. It describes the number

of seconds after entering Overflow state that a router will wait before attempting to

leave the Overflow State. This allows the router to again originate non-default AS-

external-LSAs. When set to 0, the router will not leave Overflow State until restarted.

The range for seconds is 0 to 2147483647 seconds.

Default 0

Format

exit-overflow-interval <seconds>

Mode Router OSPF Config

3.7.25.1 no exit-overflow-interval

This command configures the default exit overflow interval for OSPF.

Format

no exit-overflow-interval

Mode Router OSPF Config

3.7.26 external-lsdb-limit (OSPF)

This command configures the external LSDB limit for OSPF. If the value is -1, then

there is no limit. When the number of non-default AS-external-LSAs in a router's link-

state database reaches the external LSDB limit, the router enters overflow state. The

router never holds more than the external LSDB limit non-default AS-external-LSAs

in it database. The external LSDB limit MUST be set identically in all routers attached

to the OSPF backbone and/or any regular OSPF area. The range for limit is -1 to

2147483647.

Default -1

Format

external-lsdb-limit <limit>

Mode Router OSPF Config

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 314 315

Keine Kommentare

Kontron AT8902M CLI Bedienungsanleitung Seite 146