
KTD-S0002-I Page 41 Setup Guide
pITX-SP User's Guide
18.5.2 Onboard Device Configuration Submenu
Feature Option Description
8
Chipset Configuration Submenu Set chipset options (e.g. audio)
8
IDE Configuration
Submenu Configure the IDE devices (P-ATA, S-ATA)
8
SDIO Configuration
Submenu Configure the SDIO ports
8
LAN Configuration Submenu Configure the PCI Express
®
LAN controller
8
USB Configuration Submenu Configure the USB support
8
GPIO Configuration
Submenu Configure the GPIO port
18.5.2.1 Chipset Configuration Submenu
Feature Option Description
Audio Controller
Disabled
Enabled
Enable or disable the HD audio controller
Serial IRQ Mode
Continuous
Quiet
Define the serial IRQ mode (Quiet = the chipset transfers
only if an IRQ is triggered)
Linux Reboot Fix Disabled
Enabled
Fix the reboot issue on Linux operating systems. Might cause
side effects
18.5.2.2 IDE Configuration Submenu
Feature Option Description
Serial-ATA Controller
Disabled
Enabled
Enable or disable the S-ATA controller
Serial-ATA Type Native IDE
RAID/AHCI
Both modes needs the Option ROM
Serial-ATA Option ROM
Disabled
Enabled
If disabled legacy operating systems not available (only
Windows
®
and Linux working). Save boot time
Parallel-ATA Controller
Disabled
Enabled
Enable or disable the P-ATA controller
Parallel-ATA BusMaster Disabled
Enabled
If enabled improves the performance of the IDE interface for
some operating systems (e.g. DOS)
8
Parallel-ATA Master Submenu
Display the status of autodetection (Master drive)
8
Parallel-ATA Slave Submenu
Display the status of autodetection (Slave drive)
Hard Disk Write Protect Disabled
Enabled
Allows the write protection of harddisk devices. Only valid if
the device is accessed through the BIOS
ATA(PI) Detect Time Out 0 Sec. ... 35 Sec.
Select the time out value for the detection of ATA(PI) devices
ATA(PI) 80Pin Cable
Detection
Host&Device
Host
Device
Select the mechanism for detecting 80 pin cable
Kommentare zu diesen Handbüchern