KTD-N0793-O Page 82
7.3.13 Advanced settings – Remote Access Configuration
Configure Remote Access type and parameters
type.
<-> Select Screen
|| Select Item
+- change option
F1 General Help
F10 Save and Exit
ESC Exit
Remote Access [Enabled]
Serial port number [COM1]
Base Address, IRQ [3F8h, 4]
Serial Port Mode [115200 8,n,1]
Flow Control [None]
Redirection After BIOS POST [Always]
Terminal Type [ANSI]
VT-UTF8 Combo Key Support [Enabled]
Sredir Memory Display Delay [No Delay]
v02.67+ (C)Copyright 1985-2009, American Megatrends, Inc.
Enabled
When Enabled then a remote PC can via one of the
serial ports behave like a TTY terminal, so that
keyboard and monitor (in a terminal window) is
emulated by the remote PC. As remote PC terminal
program the Windows Hyperterminal can be used.
Setup which comport that should be used for
communication
57600 8 n 1
38400 8 n 1
19200 8 n 1
Select the serial port speed
Hardware
Select Flow Control for serial port
Redirection After BIOS POST
Boot Loader
How long shall the BIOS send the picture over the
serial port
VT100
Select the target terminal type
VT.UTF8 Combo Key Support
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals
Sredir Memory Display Delay
Delay 1 Sec
Delay 2 Sec
Gives the delay in seconds to display memory
information
Kommentare zu diesen Handbüchern