Kontron AT8404 CLI Bedienungsanleitung PDF herunterladen (Seite 150)

Switching Commands AT8404

AT8404 CLI Reference Manual Page 2 - 114

2.23.1.1 no lldp transmit

Use this command to return the local data transmission capability to the default.

2.23.2 lldp receive

Use this command to enable the LLDP receive capability.

2.23.2.1 no lldp receive

Use this command to return the reception of LLDPDUs to the default value.

2.23.3 lldp timers

Use this command to set the timing parameters for local data transmission on ports enabled for LLDP. The

<interval-seconds> determines the number of seconds to wait between transmitting local data LLDPDUs. The

range is 1-32768 seconds. The <hold-value> is the multiplier on the transmit interval that sets the TTL in local

data LLDPDUs. The multiplier range is 2-10. The <reinit-seconds> is the delay before re-initialization, and the

range is 1-0 seconds.

2.23.3.1 no lldp timers

Use this command to return any or all timing parameters for local data transmission on ports enabled for LLDP to

the default values.

2.23.4 lldp transmit-tlv

Use this command to specify which optional type length values (TLVs) in the 802.1AB basic management set are

transmitted in the LLDPDUs. Use sys-name to transmit the system name TLV. To configure the system name, see

5.8.1 “snmp-server“on page 5 - 21. Use sys-descto transmit the system description TLV. Use sys-cap to transmit

Format no lldp transmit

Mode Interface Config

Default disabled

Format lldp receive

Mode Interface Config

Format no lldp receive

Mode Interface Config

Default • interval—30 seconds

• hold—4

• reinit—2 seconds

Format lldp timers [interval <interval-seconds>] [hold <hold-value>] [reinit

<reinit-seconds>

]

Mode Global Config

Format no lldp timers [interval] [hold] [reinit]

Mode Global Config

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 372 373

Keine Kommentare

Kontron AT8404 CLI Bedienungsanleitung Seite 150