Kontron AT8404 CLI Bedienungsanleitung PDF herunterladen (Seite 301)

AT8404 Management Commands

Page 5 - 25 AT8404 CLI Reference Manual

5.8.12 snmp-server enable traps stpmode

This command enables the sending of new root traps and topology change notification traps.

5.8.12.1 no snmp-server enable traps stpmode

This command disables the sending of new root traps and topology change notification traps.

5.8.13 snmptrap

This command adds an SNMP trap receiver. The maximum length of <name> is 16 case-sensitive alphanumeric

characters. The <snmpversion> is the version of SNMP. The version parameter options are snmpv1 or snmpv2.

The SNMP trap address can be set using both an IPv4 address format as well as an IPv6 global address format.

The notification argument specifies the type (trap or inform request) for generating traps. The default is ‘trap’. The

‘inform request’ is only possible for version 2c. This is implicitely set by specifying ‘inform request’.

Example: The following shows an example of the CLI command.

(admin #) snmptrap mytrap ip6addr 3099::2

5.8.13.1 no snmptrap

This command deletes trap receivers for a community.

Default enabled

Format snmp-server enable traps stpmode

Mode Global Config

Format no snmp-server enable traps stpmode

Mode Global Config

Note: The <name> parameter does not need to be unique, however; the <name> and <ipaddr> pair

must be unique. Multiple entries can exist with the same <name>, as long as they are associated with a

different <ipaddr>. The reverse scenario is also acceptable. The <name> is the community name used

when sending the trap to the receiver, but the <name> is not directly associated with the SNMP

Community Table, See “snmp-server community” on page 5 - 21.

Format snmptrap <name> ipaddr <ipaddr>

snmptrap <name> ipaddr <ipaddr> snmpversion {snmpv1 | snmpv2}

snmptrap <name> ipaddr <ipaddr> notification {trap | inform}

Mode Global Config

Format no snmptrap <name> <ipaddr>

Mode Global Config

1 2 ... 296 297 298 299 300 301 302 303 304 305 306 ... 372 373

Keine Kommentare

Kontron AT8404 CLI Bedienungsanleitung Seite 301