Kontron AT8404 CLI Bedienungsanleitung PDF herunterladen (Seite 82)

Switching Commands AT8404

AT8404 CLI Reference Manual Page 2 - 46

2.11.14.1 no dot1x system-auth-control

This command is used to disable the dot1x authentication support on the switch.

2.11.15 dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state machine on this port.

Depending on the token used and the value (in seconds) passed, various timeout configurable parameters are set.

The following tokens are supported:

2.11.15.1 no dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state machine on this port to the

default values. Depending on the token used, the corresponding default values are set.

Format no dot1x system-auth-control

Mode Global Config

Tokens Definition

reauth-period The value, in seconds, of the timer used by the authenticator state machine on this port to

determine when re-authentication of the supplicant takes place. The reauth-period must be a

value in the range 1 - 65535.

quiet-period The value, in seconds, of the timer used by the authenticator state machine on this port to

define periods of time in which it will not attempt to acquire a supplicant. The quiet-period must

be a value in the range 0 - 65535.

tx-period The value, in seconds, of the timer used by the authenticator state machine on this port to

determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-

period must be a value in the range 1 - 65535.

supp-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to

timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.

server-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to

timeout the authentication server. The supp-timeout must be a value in the range 1 - 65535.

Default • guest-vlan-period: 90 seconds

• reauth-period: 3600 seconds

• quiet-period: 60 seconds

• tx-period: 30 seconds

• supp-timeout: 30 seconds

• server-timeout: 30 seconds

Format dot1x timeout {{guest-vlan-period <seconds>} | {reauth-period <seconds>}

| {quiet-period <seconds>} | {tx-period <seconds>} | {supp-timeout

<seconds>} | {server-timeout <seconds>}}

Mode Interface Config

Format no dot1x timeout {guest-vlan-period | reauth-period | quiet-period | tx-

period | supp-timeout | server-timeout}

Mode Interface Config

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 372 373

Keine Kommentare

Kontron AT8404 CLI Bedienungsanleitung Seite 82