
Quality of Service (QoS) Commands AT8404
AT8404 CLI Reference Manual Page 3 - 26
The following information is repeated for each class instance within this policy:
3.6.7 show service-policy
This command displays a summary of policy-oriented statistics information for all interfaces in the specified
direction.
The following information is repeated for each interface and direction (only those interfaces configured with an
attached policy are shown):
3.7 MAC Access Control List (ACL) Commands
This section describes the commands you use to configure MAC ACL settings. MAC ACLs ensure that only
authorized users have access to specific resources and block any unwarranted attempts to reach network
resources.
The following rules apply to MAC ACLs:
• The maximum number of ACLs you can create is hardware dependent. The limit applies to all ACLs, regardless
of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per MAC ACL is hardware dependent.
• For the Broadcom 5630x platform, if you configure an IP ACL on an interface, you cannot configure a MAC ACL
on the same interface.
Format show policy-map interface <slot/port> [in]
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by a forward slash.
Direction The traffic direction of this interface service.
Operational Status The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Term Definition
Class Name The name of this class instance.
In Discarded
Packets
A count of the packets discarded for this class instance for any reason due to DiffServ
treatment of the traffic class.
Format show service-policy in
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by a forward slash.
Operational Status The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface.
Note:
Kommentare zu diesen Handbüchern