Kontron AT8404 CLI Bedienungsanleitung Seite 94

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 373
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 93
Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 58
2.12.15 storm-control unicast rate
Use this command to configure the unicast storm recovery threshold for an interface in packets per second. If the
mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of unicast traffic is limited to
the configured threshold.
2.12.15.1 no storm-control uniicast rate
This command sets the unicast storm recovery threshold to the default value for an interface and disables unicast
storm recovery.
2.12.16 storm-control unicast all
This command enables unicast storm recovery mode for all interfaces. If the mode is enabled, unicast storm
recovery is active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of unknown unicast traffic
will be limited to the configured threshold.
2.12.16.1 no storm-control unicast all
This command disables unicast storm recovery mode for all interfaces.
2.12.17 storm-control unicast all level
This command configures the unicast storm recovery threshold for all interfaces as a percentage of link speed and
enables unicast storm recovery. If the mode is enabled, unicast storm recovery is active, and if the rate of unknown
L2 unicast (destination lookup failure) traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured threshold.
Default 0
Format storm-control unicast rate <0-33554431>
Mode Interface Config
Format no storm-control unicast rate
Mode Interface Config
Default disabled
Format storm-control unicast all
Mode Global Config
Format no storm-control unicast all
Mode Global Config
Default 5
Format storm-control unicast all level <0-100>
Mode Global Config
Seitenansicht 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 372 373

Kommentare zu diesen Handbüchern

Keine Kommentare