Kontron AT8404 CLI Bedienungsanleitung PDF herunterladen (Seite 42)

Switching Commands AT8404

AT8404 CLI Reference Manual Page 2 - 6

2.1.11 speed

This command sets the speed and duplex setting for the interface.

2.1.12 speed all

This command sets the speed and duplex setting for all interfaces.

2.1.13 show port

This command displays port information.

Format speed {<100 | 10> <half-duplex | full-duplex>}

Mode Interface Config

Acceptable Values Definition

100h 100BASE-T half duplex

100f 100BASE-T full duplex

10h 10BASE-T half duplex

10f 10BASE-T full duplex

Format speed all {<100 | 10> <half-duplex | full-duplex>}

Mode Global Config

Acceptable Values Definition

100h 100BASE-T half duplex

100f 100BASE-T full duplex

10h 10BASE-T half duplex

10f 10BASE-T full duplex

Format show port {<slot/port> | all}

Mode Privileged EXEC

Term Definition

Interface Valid slot and port number separated by a forward slash.

Type If not blank, this field indicates that this port is a special type of port. The possible values are:

• Mirror - this port is a monitoring port. For more information, see 2.14 “Port Mirroring” on

page 2 - 75.

•PC Mbr- this port is a member of a port-channel (LAG).

•Probe - this port is a probe port.

Admin Mode The Port control administration state. The port must be enabled in order for it to be allowed

into the network. - May be enabled or disabled. The factory default is enabled.

Physical Mode The desired port speed and duplex mode. If auto-negotiation support is selected, then the

duplex mode and speed is set from the auto-negotiation process. Note that the maximum

capability of the port (full duplex -100M) is advertised. Otherwise, this object determines the

port's duplex mode and transmission rate. The factory default is Auto.

Physical Status The port speed and duplex mode.

Link Status The Link is up or down.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 372 373

Keine Kommentare

Kontron AT8404 CLI Bedienungsanleitung Seite 42