Kontron AT8404 CLI Bedienungsanleitung PDF herunterladen (Seite 46)

Switching Commands AT8404

AT8404 CLI Reference Manual Page 2 - 10

2.2.8.1 no spanning-tree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch

is currently using to the default value.

2.2.9 spanning-tree edgeport

This command specifies that this port is an Edge Port within the common and internal spanning tree. This allows

this port to transition to Forwarding State without delay.

2.2.9.1 no spanning-tree edgeport

This command specifies that this port is not an Edge Port within the common and internal spanning tree.

2.2.10 spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value.

• Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE 802.1d functionality

supported).

• Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s functionality supported).

• Use 802.1w to specify that the switch transmits RST BPDUs rather than MST BPDUs (IEEE 802.1w

functionality supported).

2.2.10.1 no spanning-tree forceversion

This command sets the Force Protocol Version parameter to the default value.

Mode Global Config

Format no spanning-tree configuration revision

Mode Global Config

Format spanning-tree edgeport

Mode Interface Config

Format no spanning-tree edgeport

Mode Interface Config

Default 802.1s

Format spanning-tree forceversion <802.1d | 802.1s | 802.1w>

Mode Global Config

Format no spanning-tree forceversion

Mode Global Config

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 372 373

Keine Kommentare

Kontron AT8404 CLI Bedienungsanleitung Seite 46