Kontron AT8404 CLI Bedienungsanleitung PDF herunterladen (Seite 308)

Management Commands AT8404

AT8404 CLI Reference Manual Page 5 - 32

5.8.36 show boardinfo snmp ipmi-trap

This command displays the settings for generation of IPMI traps. It displayes the general setting as well as all filter

rules..

5.9 RADIUS Commands

This section describes the commands you use to configure the switch to use a Remote Authentication Dial-In User

Service (RADIUS) server on your network for authentication and accounting.

5.9.1 authorization network radius

Use this command to enable the switch to accept VLAN assignment by the radius server.

5.9.1.1 no authorization network radius

Use this command to disable the switch to accept VLAN assignment by the radius server.

5.9.2 radius accounting mode

This command is used to enable the RADIUS accounting function.

5.9.2.1 no radius accounting mode

This command is used to set the RADIUS accounting function to the default value - i.e. the RADIUS accounting

function is disabled.

5.9.3 radius server attribute

This command specifies the RADIUS client to use the NAS-IP Address attribute in the RADIUS requests. If the

specific IP address is configured while enabling this attribute, the RADIUS client uses that IP address while sending

NAS-IP-Address attribute in RADIUS communication.

Format show boardinfo snmp ipmi-trap

Mode Privileged Exec

Default disable

Format authorization network radius

Mode Global Config

Format no authorization network radius

Mode Global Config

Default disabled

Format radius accounting mode

Mode Global Config

Format no radius accounting mode

Mode Global Config

1 2 ... 303 304 305 306 307 308 309 310 311 312 313 ... 372 373

Keine Kommentare

Kontron AT8404 CLI Bedienungsanleitung Seite 308