Kontron AT8404 CLI Bedienungsanleitung PDF herunterladen (Seite 291)

AT8404 Management Commands

Page 5 - 15 AT8404 CLI Reference Manual

5.7 User Account Commands

This section describes the commands you use to add, manage, and delete system users. FASTPATH software has

two default users: admin and guest. The admin user can view and configure system settings, and the guest user

can view settings.

5.7.1 users name

This command adds a new user account, if space permits. The account <username> can be up to eight characters

in length. You can use alphanumeric characters as well as the dash (‘-’) and underscore (‘_’). You can define up to

six user names.

5.7.1.1 no users name

This command removes a user account.

5.7.2 users name <username> unlock

Use this command to unlock a locked user account. Only a user with read/write access can re-activate a locked user

account.

5.7.3 users passwd

Use this command to change a password. Passwords are a maximum of 64 alphanumeric characters. If a user is

authorized for authentication or encryption is enabled, the password length must be at least eight alphanumeric

characters. The password is case sensitive. When you change a password, a prompt asks for the old password. If

Note: You cannot delete the admin user. There is only one user allowed with read/write privileges. You

can configure up to five read-only users on the system.

Note: The <username> is not case sensitive when you add and delete users, and when the user logs

in. However, when you use the <username> to set the user password, authentication, or encryption, you

must enter the <username> in the same case you used when you added the user. To see the case of

the <username>, enter the show users command.

Format users name <username>

Mode Global Config

Format no users name <username>

Mode Global Config

Note: You cannot delete the “admin” user account.

Format users name <username> unlock

Mode Global Config

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 372 373

Keine Kommentare

Kontron AT8404 CLI Bedienungsanleitung Seite 291